For my door panels which were in terrible condition I coated them in fiberglass epoxy.
Didn't even add any fiberglass and it worked quite well to make them pretty strong.
For the door push pins I used metal washers to reinforce the holes as most were pulled through.

Finally around the ...

For my door panels which were in terrible condition I coated them in fiberglass epoxy.
Didn't even add any fiberglass and it worked quite well to make them pretty strong.
For the door push pins I used metal washers to reinforce the holes as most were pulled through.

Finally around the window ...

Great guide I wish I had found it before I did my AC refresh on my 951!
I bought a roll of rubber adhesive strips 2 inch wide by 1/8 inch thick to wrap around the Drier and it worked great.
Center vent temp of 39F with 27oz of R134. 85F outside with about 243% Humidity so it was feeling nice ...

This is going to be Epic! While I love my 3d Printed tool this will be way cooler to show off at the car show!

This looks great I printed one to test fit in PLA (ASA ran out) and took it to my shop but left it next to a halogen light and melted it! Reprint time!

Do you have a link of what material you used?

Well, it was 92F out today and the a/c is still blowing super cold. :thumbup: At the risk of jinxing it, I'd say the eBay Condenser from Cooler Classics is a success!


That's good to know that it all worked out with Cooler Classics. I just installed a new Compressor and am only getting it down ...

Email Sent
I'm excited to get this for my Turbo
Thanks for helping the community with this!

Tom wrote: Mon Jun 03, 2024 9:12 am What year and model is your car? I have Bruce's old inventory, just haven't had the time to pull together kits. If I know which kit you need, I'll try to assemble a kit for you.

86 Turbo
No rush, just excited to finally have a fix!

Any updates?
Thanks for working on this

Can't wait to get this was looking to build my own kit but sourcing the exact parts was looking difficult