This is a replacement of 931 116 177 00, which is missing on many cars. Use an elastomeric material like TPU.

Hello, I managed to get a very cheap ATIWE 32 steering wheel. It has a very similar design to the original club steering wheel.

IMG_20260421_174443.jpg

However, I didn't find any hub on the market. Hubs from Luisi are for sale. These have a different bolt hole pattern than the Atiwe steering ...

Hello, here is the model of the faceplate.

NOTE: I did not try it yet, since my was broken, but I was capable to glue it together. I have just seen that someone is selling the model for 5 bucks. It is quite easy one, so I model it.

Hello, I made a phone holder that attaches to the central vent. It is two parts that are glued together. I printed from ABS and glued with acetone. For the size of your phone, the part into which the phone is inserted must be dimensionally adjusted. The internal dimensions are 74mm wide and 10mm ...

My rear headliner panel is quite deformed. I glued it to ceiling but it still doesn't hold. As a temporary solution I printed these clips that go under the rear hatch seal profile.

Here's one I've been using for a while.

It has a o-ring groove (i forget the size o-ring but its 1.5mm chord dia).

It comes out a bit steppy due to having the radius surface, but a bamboo with 'ironing' may improve that (not tested) else some finishing if you so please...

Some flats to help ...

angrymancunian wrote: Tue Jan 20, 2026 11:26 am Think this one will do? http://www.thingiverse.com/thing:2537084

No, as you can see from photos, it is a different part.

Hello, it is not tricky to create a model, but taking in mind it is 12USD from Pelican, is not make much sense... The original part is quite thin, so the 3D print will be pretty fragile, or you have to adjust it to be more robust.

Hello, it's super easy to model it. Just measure the diameter of the hole and the thickness of the glass. I will do it.

The Porsche 968 has an installation opening for clutch replacement. This makes it possible to replace not only the clutch or flywheel, but also the rear crankshaft seal. Due to limited space, seal installation is complicated. This tool ensures that the seal is pressed in using flywheel bolts ...