PTRogers85 wrote: Fri Jul 01, 2022 8:30 pm Thanks Tom! I'll definitely have to print one, good thing I recently bought a 944 andinread on changing the timing belt and balance shaft belt before I drive it any further.
New 3D-Printed 944 Timing Belt Tensioner Tool
-
Tom
- Site Admin
- Posts: 8564
- Joined: Fri Jun 25, 2021 2:04 pm
- Location: Silicon Valley, CA
- Has thanked: 891 times
- Been thanked: 3845 times
- Contact:
Welcome aboard! And yes, see our store here:rfrx7phx7 wrote: Wed Jan 14, 2026 7:49 pm Your new belt tensioner tool looks great. I don't have a 3D printer. Is there anyway that I can buy one?
Thanks:
Ray
app.php/carpokes-store
-
Tom
- Site Admin
- Posts: 8564
- Joined: Fri Jun 25, 2021 2:04 pm
- Location: Silicon Valley, CA
- Has thanked: 891 times
- Been thanked: 3845 times
- Contact:
Unfortunately, it does not.hennigc wrote: Sat Jan 17, 2026 6:52 pm This might be a dumb question, but does this work on a 16 valve S2 engine as well?
Just wanted to get an opinion before I print again. I initially printed this in PET-G and found it was clicking way too tight. I am unable to move the water pump freely at all. Should I try prining in ASA as its less flexible? Could that be the issue? I've tried with two different torque wrenches and both are the same.
1987 Porsche 944 NA - Alicante, Spain
-
JohnnyChopsticks
- Posts: 1
- Joined: Tue Jan 20, 2026 12:15 pm
Thanks for posting the files, I may end up just buying one anyway as support!