Page 2 of 2
Re: Cubby below radio
Posted: Sat Jan 17, 2026 12:07 pm
by Damo
angrymancunian wrote: Sat Jan 17, 2026 3:45 am
Any Chance you have the design files for the cubby?
I've attached an export from Audodesk Fusion to the original post at the top.
Re: Cubby below radio
Posted: Sat Jan 17, 2026 12:16 pm
by Damo
Also, an update on the PLA print I have in my car. I used Overture PLA+ which prints at 230 degrees C and after 10 months and some hot summer drives (30 degrees C) it hasn't deformed. So far so good.