Carpokes

I'll try this on my next belt replacement.

cool

Very cool design. I for sure will try this on my 944. Thank you!

Another fly in for this timing belt tool. Thank you carpokes for offering this!

This will come in handy, thanks.

Also, for my 88 944 base, do i need the spanner wrench, thin wrench and flywheel lock tools? Or are there clever work arounds?

Im also changing the water pump?

howdo wrote: Thu Jan 25, 2024 8:11 pm This will come in handy, thanks.

Also, for my 88 944 base, do i need the spanner wrench, thin wrench and flywheel lock tools? Or are there clever work arounds?

Im also changing the water pump?

Tom or others will be able to help you, so hopefully someone will notice your question. Meanwhile, here's the link to a Carpokes thread regarding 944 flywheel lock that Tom initiated back in March.

viewtopic.php?t=1687

Welcome to Carpokes!

howdo wrote: Thu Jan 25, 2024 8:11 pm This will come in handy, thanks.

Also, for my 88 944 base, do i need the spanner wrench, thin wrench and flywheel lock tools? Or are there clever work arounds?

Im also changing the water pump?

Thin wrenches are in the 'very nice to have' category, but you can get away without them if you have a well stocked tool chest. You need a flywheel lock to get the front pulley off (don't try to 3D print it, it won't be strong enough.). The balance shaft pin-wrench is a near-necessity to get the b/s sprockets off. We have one you can 3D print for the job.

viewtopic.php?p=21781&hilit=pin+wrench#p21781

And welcome aboard!!

About to replace water pump and belt going to give this a shot

Thanks for posting this OP!

Fantastic tool, thanks so much