Carpokes

You guys can count me in if this anodized aluminum version comes through.

I would definitely be interested

Depending on the price per set I would order multiple sets to offer to Spyder owners here in SW Florida.

I have an interest in at least 5-6 sets so far.

Bob Z wrote: Sun Dec 04, 2022 6:49 pm I have an interest in at least 5-6 sets so far.

That helps. We may need to underwrite more just to get the per-piece cost manageable, but I should get prices from the shop soon. So much of the cost is set up, I'd guess the difference in price between 5 sets and 50 will be pretty small, but will report back when I get the quote. I'll also check to see if we can run a few test pieces before doing them all, to confirm the fit. That may be a possibility once we are committed to a batch...

I we had a sample I am sure we could sell more! Some have asked me if the Black will be a close match to the surrounding area...

Depending on the price I might order up to ten sets. I know at least that many Spyder owners in my area. I would just sell them for what I pay for them.

srm

Good Morning Tom,

I'm in to five sets...one set for myself and the others at cost for Spyder owners here in our local PCA chapter. Thanks very much for doing this!!

Jim

Just so everyone is on the same page, these would be perfectly flat 1/8" thick aluminum that you would need to affix to the car yourself, presumably with Velcro like Bob did....

Correct!