Page 1 of 1
Request for STL File: Porsche 944 Phase 2 Rear Wiper Delete
Posted: Thu Nov 20, 2025 1:35 am
by LaAudiBidon
Hi!
I’m looking to find out if anyone has created an STL file for a rear wiper delete on a Porsche 944 Phase 2.
I found this part here:
https://partworks.de/partworks/fr/10378 ... XL49k_kHWg , but it’s quite expensive, which is why I’m wondering if a 3D-printable STL file exists.
Thanks in advance for any help!
Greetings from France!
Re: Request for STL File: Porsche 944 Phase 2 Rear Wiper Delete
Posted: Sat Jan 03, 2026 12:09 pm
by MetalWolf
this would be very helpful
Re: Request for STL File: Porsche 944 Phase 2 Rear Wiper Delete
Posted: Tue Jan 13, 2026 4:34 am
by Silver99
Hello, it's super easy to model it. Just measure the diameter of the hole and the thickness of the glass. I will do it.
Re: Request for STL File: Porsche 944 Phase 2 Rear Wiper Delete
Posted: Thu Jan 15, 2026 6:22 pm
by Wardie100
Here's one I've been using for a while.
It has a o-ring groove (i forget the size o-ring but its 1.5mm chord dia).
It comes out a bit steppy due to having the radius surface, but a bamboo with 'ironing' may improve that (not tested) else some finishing if you so please...
Some flats to help tighten would be nice, but I managed without!
Re: Request for STL File: Porsche 944 Phase 2 Rear Wiper Delete
Posted: Thu Jan 22, 2026 12:06 am
by Silver99
Wardie100 wrote: Thu Jan 15, 2026 6:22 pm
Here's one I've been using for a while.
It has a o-ring groove (i forget the size o-ring but its 1.5mm chord dia).
It comes out a bit steppy due to having the radius surface, but a bamboo with 'ironing' may improve that (not tested) else some finishing if you so please...
Some flats to help tighten would be nice, but I managed without!
Hello, your part is for a hole diameter 16mm.
2026-01-22 08_51_41-WIPER_BUNG_1_ (Active) - Creo Parametric.png
I created simple one piece plug for 968. The hole diameter is 26mm and glass thickness 4mm. Of course, you need to print it from elastomere. On FDM printers, some TPU, I have access to SLS printer, so I choose transparent material.
2026-01-22 08_57_38-Greenshot.png
You can play with the file in OnShape
https://cad.onshape.com/documents/54587 ... fe51194acd