Page 1 of 1
Request for STL file : Porsche 968 End Cap for Rear Wiper
Posted: Tue Jan 06, 2026 6:09 pm
by rwodabek
Hello all,
I'm wondering if anyone has found or created an STL file for the end cap for the rear wiper on the 968. I've checked around and couldn't find anything for the 968.
I've got a 1994 968 with 315K on it and deserves to have the cap
I've attached pics for reference.
Thanks,
Richard.
Re: Request for STL file : Porsche 968 End Cap for Rear Wiper
Posted: Tue Jan 13, 2026 6:41 am
by Silver99
Hello, it is not tricky to create a model, but taking in mind it is 12USD from Pelican, is not make much sense... The original part is quite thin, so the 3D print will be pretty fragile, or you have to adjust it to be more robust.
Re: Request for STL file : Porsche 968 End Cap for Rear Wiper
Posted: Tue Jan 20, 2026 11:26 am
by angrymancunian
Re: Request for STL file : Porsche 968 End Cap for Rear Wiper
Posted: Wed Jan 21, 2026 11:49 pm
by Silver99
No, as you can see from photos, it is a different part.
Re: Request for STL file : Porsche 968 End Cap for Rear Wiper
Posted: Sat Feb 14, 2026 9:51 am
by rwodabek
Silver99 wrote: Tue Jan 13, 2026 6:41 am
Hello, it is not tricky to create a model, but taking in mind it is 12USD from Pelican, is not make much sense... The original part is quite thin, so the 3D print will be pretty fragile, or you have to adjust it to be more robust.
You're right. The part itself is inexpensive and I ended up buying it. I just got into 3D printing and was curious if I could find one and see if it would have worked.