Hey Tom, completely off topic, but I was doing some reading and internet searches and noticed you got the factory boost gauge working with a Arduino, you wouldn’t happen to have a link sharing that build and the code would ya? I’d like to get mine running and have a spare Arduino sitting here ...

Hey Tom, completely off topic, but I was doing some reading and internet searches and noticed you got the factory boost gauge working with a Arduino, you wouldn’t happen to have a link sharing that build and the code would ya? I’d like to get mine running and have a spare Arduino sitting here

944m3 wrote: Tue Feb 27, 2024 12:10 pm Did you print the coil holders yourself or are they available to purchase from the creator?

I purchased them as it’s way better than anything I could print on my old Ender, you can contact him on Facebook see photo. Just let him know I sent you.

Looking good. I wondered where you went -- looks like you've been busy! Are those 3D-printed coil holders? Is that system capable of sequential injection? I would be temped to try it if so.


Im always around tinkering with something! Yea they are 3D printed from another 944 member, I forget the ...

944m3 wrote: Mon Feb 26, 2024 10:37 am That is a clean engine bay. Looks great.

Does the drivability differ in any way from MAF or very similar? I’m assuming you are using MAP?

It’s feels much better, more like a modern cad, smooth power, but that might also be because I have way better tuning ability with this software

Haven’t posted in a while, just wanted to follow up on my project, over the winter I finish swapping over to a microsquirt stand-alone and coil on plug setup. Got her running over the weekend, so far I’m on my 4th revision of the tune, running 17.5psi goal is to eventually bring it to 25psi. Like I ...

Any of you guys running water/meth injection? Just looking to see what your tunes look like

I’m currently setup with a stage 2 snow performance kit, with a 10gph v2 Nozzel about 10inches from the throttle body. It’s on a progressive controller, injection starts at 9psi and is at full by 18psi and ...

Looks awesome I really like that powder coat, I’ll have to do mine. I mocked these 2.5” pipes up and had a friend weld them up, wish the pie cut came out cleaner but that’s what happens when you use a friends lol

Looks awesome TOM, I was able to get the stock one to fit with some trimming, I like yours better! I also added some intercooler sprayers

Back on the road!